A query from one of our members: TS2068 Larkenized Oliger System

See all articles from Sinc-Link v10 n5
Author(s): George Chambers
Publication: Sinc-Link
Pub Details: Sinc-Link v10 n5 (Volume 10, Issue 5)
Date: September/October 1992
Pages: 32

I had a request from one of our members, Larry Crawford, in which he asks for some information about the Larken cartridge used in his Oliger TS2068 system. I’ll quote from his letter:

“Dear George,

“Thought that I would drop you a line to let you know that I’m operational once more. Solved the Oliger problem by replacing the computer. The Larken cartridge was more of a challenge.

“I found a couple of traces and a pad which managed to get messed up when I hacked out the IC’s to instal sockets. But even after I patched them up, the board would not work. In desperation, I traced the whole board to produce a schematic. After I did that, the problem was obvious. Pin 10 of the ’74 (the S terminal of the latch) went to a donut hole and nowhere else. To satisfy the logic of the chip, I put in a 10K pull-up resistor and now it works.

I have no idea what happened to the original one. What is on your cartridge? The hole connected to pin 10 is crammed in between the ’74 and the EPROM.

I’m enclosing a copy of the schematic in case anyone else runs into problems with the board……..” End of quote.

When I looked at my cartridge I found that it differed. Larry’s cartridge is modified to work with the Oliger, and this evidently required that a small switch be installed on the cartridge. On my cartridge there is a trace from the donut hole that goes to the chip. Which pin is not evident from a visual inspection since the trace goes underneath the chip. But there is nothing wired to the donut hole. Larry’s schematic shows pin 10 on the 74HCT74 chip going, via the donut hole, to the “OFF” side of the switch. The question is, what does your cartridge show?

I think we shall publish L.C.’s schematic. But I suggest that we will hold off until we get a similar one for the original Larken cartridge. If an Oliger-owning member wishes to have a copy in the meantime, just ask.