Another $100 Misunderstanding

Author(s): Bob Nadler
Publication: Syntax
Pub Details: Syntax/Syntax ZX80 v3 n3 (Volume 3, Issue 3)
Date: March 1982
Pages: 11

I just finished rebuilding my ZX81 kit. If Sinclair had sent complete instructions with my kit (delivered in early Jan.82) I would not have needed to reopen the case, desolder and remove two components, and add seven new ones. I can’t believe that Sinclair singled me out to receive a kit with incomplete instructions, so what follows may help others whose ZX81s won’t work and wonder why they have two resistors, two capacitors, two little red coils and an oddly shaped metal strip left over after finishing the assembly per instructions.

Instructions with my kit called for only 12 capacitors (C1-C12) to be installed on the board. They didn’t mention two red-wire induction coils. They offered no special instructions for installing R27 and R29. And they didn’t even mention a grounding strip, let alone describe how to install one. If the instructions you got are similarly lacking, take note.

Sinclair advises (after I wrote) that you install R27 and R29 vertically. You should find two pairs of resistors of the correct values (R27=1K, R29=1M). Use the pair that are preformed for vertical installation.

You will also find two surplus 47nF capacitors (marked 473 Z) when you finish the assembly per the instructions. These are C13 and C14. It’s easy to spot the board location for C13, but the callout for C14 is hidden under the 9V jack. The C14 location is between the end of the jack and the edge of the board.

It is easy to spot the locations for inductors I1 and I2, just above the regulator. Plug the red-wire coils into these locations (I1 and I2 bring the 9V supply to the regulator, without them the board is stone-cold dead). Solder all these components to the board.

Finally, install the left-over weird-looking metal strip so that its long bent-up end passes between the heat sink and the edge of the board, with that end in position to contact the top of the case once the board is screwed down. Solder the other end of the strip to the arrow-shaped area just below the slot in the board. Then solder the other portion of the strip with a single small hole in it to the rectangular area provided adjacent to the regulator.

My 8K/1K ZX81 ran satisfactorily with horizontal rather than vertical resistors, without the two additional capacitors, and without the grounding strip. It runs even better now with the changes and added components. The TV display is clearer and more steady and seemingly, keyboard entry is faster and easier.