SOURCE: ZX COMPUTING FEB/MARCH 1983 TIM HARTNELL AND IAN BEARDSMORE SUMMARISE ADVICE FROM MEMBERS OF THE NATIONAL ZX USERS’ CLUB.
CONQUERING LOAD/SAVE PROBLEMS.
Some of the following advice will not be relevant to your particular computer/cassette setup, so read through all the advice we give until you find something that appears to apply to you, and then try out the suggestions given.
IN A JAM?
Make sure the outputs from your cassette player are compatible, that is you have 3.5mm sockets, and check that the plugs fit firmly. Some appear to work better if they are moved a fraction of an inch out of the computer, rather than being jammed hard into the ZX81. The ZX80 and the ZX81 need four to six volts peak output.
If you have a 16K program, trying SAVEing, then LOADing a very short program without the pack on, and then with it in place. If they both LOAD/SAVE, then try a longer program. If the longer program does not LOAD/SAVE, then the problem could be overheating, something that can cause problems within 15 minutes of turning the computer on.
If you get LOAD/SAVE problems only with the 16K RAM PACK attached, then try the following ideas. They sometimes bring results, even with mischievous RAM packs.
1. Keep your ZX cool. This can be done by using a fan, or by placing something cold on top. Tim’s first book, MAKING THE MOST OF YOUR ZX80, was written with the aid of a succession of frozen LONG LIFE milk cartons. If you follow this somewhat bizarre idea, make sure that the water doesn’t get into the computer. If you have an extreme heating problem, and you feel confident of your ability to do it, you can take the top off, and/or solder in an extra heatsink.
2. Don’t jar the computer while SAVEing or LOADing.
3. Try different volume levels when LOADing, and keep the tone control on the maximum (in full treble). You’ll need a lot of volume in most cases, and a maximaum treble.
4. Noise can be a source of LOADing problems. There should be about five seconds of silence before a program. Tape hiss is not conducive to a successful load.
5. Use good, proper computer cassettes, rather than cheap low-noise audio ones. Quality audio cassettes (such as TDK) generally work well.
6. Clean the tape head frequently, and if you can get one – use a demagnetiser from time to time.
7. If your cassette recorder has batteries, try it with them, rather than running the recorder from the mains. You should find this helps.
8. Make several copies of each program, so that if one doesn’t load, you can always try the next one on the tape. Frequent use of a tape (or one portion of it) will lead to a buildup of hiss over the program, which may eventually make it impossible to load from.
ADJUSTING AZIMUTH.
Mr. S. Atkinson of Harrogate suggests the following. He points out that, for loading, the output from the cassette needs to contain as much treble as possible. You can increase the treble content of the recorder’s output by changing the tape head azimuth, the alignment between the tape head and the tape.
The tape head on most cassette machines is mounted on two screws, one of which is sprung. By adjusting this screw, the tone can be altered. The screw is accessed by a small hole above the play head. In many cases, this hole is covered by tape, or a small metal plate.
Here’s how you can adjust your azimuth:
1. turn the recorder controls to maximum treble, minumum bass, and insert a tape containing a program.
2. With the earpiece out, start the recorder.
3. Adjust the screw, trying it in both directions, until the sound is as “tinny” as possible.
Note that this may make some of your music cassettes sound a little too sharp for your liking.