Publication: Syntax
Pub Details: Syntax/Syntax ZX80 v3 n3 (Volume 3, Issue 3)
Date: March 1982
Pages: 20-21
My 16K RAM pack tended to dump its memory if my ZX81 was moved, wiggled, or tapped, or if the RAM pack was squeezed. Sometimes it dumped for no apparent reason. I suspected the problem was caused by dirty contacts at the edge connector, but cleaning the contacts had no effect. The cause was mechanical instability in the RAM pack itself. The problem took only five minutes to fix, and now my ZX81 with 16K attached can withstand any amount of wiggling, shaking or thumping without a memory dump. This procedure worked for me:
- Open the RAM pack case by removing the 4 screws and pulling the halves apart gently. Inside are 2 boards hinged together at the top by a ribbon cable, book-fashion.
- Inside the front and rear halves of the case you’ll find large tan-colored cardboard insulators. With a pair of scissors, trim the notches in the insulators so they just clear the screw posts.
- On a lower corner of the front board (the one with the blue plug attached) you will note 2 grounding springs that are designed to make contact with the metallized coating of the case when it is assembled. Inspect this area of the board to see if the pins running from the blue plug project far enough above the rear of the board to make contact with the grounding springs when they are flexed. If this appears possible, nip off the projecting pin ends as close as possible to the surface of the board and cover them with a piece of vinyl electrical tape.
- On the boards in my unit, only 2 of the electrolytic capacitor cans had vinyl electrical tape on top of the cans to prevent shorting to the opposing board when the boards were folded together. Place vinyl tape on top of ALL the cans, and as an extra precaution stick a strip of tape on the bottom surface of the opposing board.
- Reassemble the RAM pack, making sure that the lower grounding spring on the front board makes contact with the metallized coating on the inside of the of rear half of the case. If necessary, bend it gently to insure that it makes proper contact. The side grounding spring will be pinched between the two halves of the case when it is properly assembled.