Get Your System Together

Author(s): Jon Harder
Publication: Syntax
Pub Details: Syntax/Syntax ZX80 v4 n3 (Volume 4, Issue 3)
Date: March 1983
Pages: 16

Your ZX/TS is compact but can give you that “all over the place” feeling with snarled cables, loose RAM pack problems, and instability.

One easy, but expensive, cure is an encased keyboard that holds your ZX board inside.

This cheaper way doesn’t take much time and uses materials you may already have:

1) 10″ x 16″ shelving, 3/4″ thick.
2) Double-stick transparent tape.
3) Four-inch foam mounting tape.
4) Adhesive-backed felt.
5) Rubber selfstick 1/2″ squares.
6) Neon nightlight, 1/4 watt.
7) Extension cord (in-line switch).

Raise your ZX/TS with four new feet to make it more stable when typing. This also raises your RAM pack, reducing risk of crashes when typing shifted characters.

Next, place your ZX/TS with RAM, printer and power pack on the board in a pleasing and simple layout. Coil up the 9V DC cord and leave just enough to reach your ZX case. You can turn your ZX/TS on and off with the AC cord switch.

Check your system layout for convenience and find the shortest wire length for each connection. Use foam tape to mount the power pack with its prongs to the back so you can bring the extension to it easily. Plug the night light into the end and use a side connection as the AC supply to the pack. When the power is on, the light is on.

Pass the cables under your computer to neaten up your system’s layout. Put double-stick tape on each new rubber foot and position your ZX/TS where you want it–press firmly until secure. Mount your printer the same way.

One more plus: a 10″ x 16″ board fits inside many attache cases, so you can travel with your whole system. A few bucks gives your ZX/TS dignity.