Larken Tips

See all articles from Sinc-Link v4 n6
Author(s): George Chambers
Publication: Sinc-Link
Pub Details: Sinc-Link v4 n6 (Volume 4, Issue 6)
Date: November/December 1986
Pages: 9

I am going to detail three unusual conditions which I have encountered with the LARKEN drive, and the explanation of them.

1. RAMTOP gets set to a low number (PRINT FREE 36604) and cannot seem to be reset to the normal value of (PRINT FREE) 38652.

ANSWER…The computer has been bank-switched (84,64) for the LARKEN drive. Do an 84,0, and RANDOMIZE USR 0. The computer will re-initialize and set a new RAMTOP.

2. BASIC loader program gets corrupted when using the LDOS16 to load a subsequent program.

ANSWER…This comes about through using RANDOMIZE USR 16000 rather than RANDOMIZE USR 16384. Although using 16000 appears to work OK, it actually goes into the 2068 ROM area and produces the quirk mentioned above.

3. The LDOS cursor sometimes appears with an underline below it. Although faulty entries can be deleted the underline remains.

ANSWER..What has happened is that the OVER 1 commamnd has been placed in the computer by a previous program and has not been cleared out (by the DOS). This failure to detect and remove the OVER 1 command might be considered a DOS bug. Get into BASIC and do an OVER 0 command.