Now I will editorialize about PRINTERS in general. Just a couple of years ago ANY dot matrix printer that had a “Near Letter Quality” mode would cost a guy upward of $500. Then along came the CLONES. I bought a Seikosha SP-1000, an Epson Clone, for $225.00. That was in 1986. It replaced a Okidata ML 82 that I had worn out. How do you wear out a printer? Well, the print head is the weakness. The maker guarantees them for a few million characters, which sounds like forever. But consider that a page usually has about 3500 characters, and then a million characters takes on a smaller meaning. So, why not just replace the print head when one wears out? Yep, good idea, but a print head runs around $90-150 depending upon the printer type. Generally I find that the Clone printers have smaller print heads than the printers that they emulate. The smaller print heads naturally wear out sooner, but are not as expensive to replace.
But, 7 pin printers are now becoming obsolete, and is it cost effective to spend $90 to replace a print head? Nine pin printers are also becoming obsolete. New 7 and 9 pin printers are now being sold at good discount prices. I’ve seen my Seikosha 1000 advertised for as little as $149.95 recently. The 24 pin printers are now taking over. Prices range from a low of $350.00 upward to over $1000.00. So, one has a choice of buying a good 7 or 9 pin printer at a discount price, or going for the newest. The 24 pin printers are reputed to have TRUE letter quality at high speed, and high resolution graphics printing. But, some of the older model printers do a very good job in NLQ mode. But one can expect about 25 characters per second speed of printing in the NLQ mode.
Me? Well heck! I have tried NLQ dot matrix print and it doesn’t measure up to the quality needed for publishing a magazine. So I’m using two Daisy Wheel printers, one on the TS-2068 and the other on the QL. One cost $179.00 and the other cost $275.00 from mail order sources. Daisy Wheel printers lack the Graphics that a dot matrix printer has, and have fewer Type Fonts to choose from. But a Daisy wheel printer produces “TYPEWRITER QUALITY” print, actually better than most typewriters. But the printing is slow, about 17 characters per second. I have my eye out for a good bargain in a new 24 pin Dot Matrix, mainly for quality graphics printing.
A PRINTER BUFFER can mitigate the slowness of a printer. The printer buffer is hooked up “in line” between the computer and the printer. When the computer directs a print operation, the printer buffer takes the data (which has the printer control codes mixed in) as fast as the computer can send the data. Usually a 64K printer buffer will store as much data as most people want to print at one time (about 20 pages). The computer and its software sends the data quickly to the printer buffer, and then the computer is ready to do other things while the data is being printed. One can just STORE the data in the buffer until ready to print it. And, some buffers have the capability of keeping the data intact to print several copies if desired. A 64K printer buffer costs approximately $150-225. (Read the fine print.)
SERIAL AND PARALLEL PRINTERS: The QL can use either with the software that it uses. A Serial printer is hooked directly to either of the Serial Ports of the QL. The use of a PARALLEL printer with the QL requires a small in-line Parallel Interface. Most of the available interfaces connect directly to the data input of a printer. Generally, a Centronics Parallel printer has wider capabilities than does serial printers and it is worth the extra $40.00 cost of the interface. The TS-2068 and almost all of its software and hardware is designed for Centronics PARALLEL printers.
ALL WE NEED to know about printers? Hardly! We all need to know more about the adaptability of both the TS-2068 and the QL for 24 Pin Printers.