For some time now I have been experiencing a problem with one of my disk drives on my #2 QL, in that I could not always format a disk in #2 drive. I would get a “Failed” message, or the disk would be formatted with less than the correct number of sectors. I was able to use this drive to write to, and to read, with no apparent problem, but format was unreliable.
This particular setup has three drives on the Trump Card:-
#1 5 1/4 720 #2 3 1/2 DD #3 5 1/4 360
I am able to use three drives on the Trump Card as I obtained from Miracle Systems a small adapter (card) which permits the Trump or the Gold Cards, to handle up to four drives. This configuration means that in conjunction with my #1 QL, I can copy the TorQLib Library to just about any configuration that may be presented to me by a member.
Recently I had occasion to be copying some disks for someone who sent me 5 1/4 disks, and in the process of copying I found one of his disks “Not Found” which usually means it has not been formatted. I reformatted it in #1 a number of times with varying results, none of them correct. I returned it to him, and he replied that he had no problem with that disk, that it formatted, was written to, and was readable with no difficulty.
I then recalled another member who had a setup similar to mine, and he was having trouble of a like nature. I began to ponder if the problem could be in the small Disk Adapter, so I made a few test runs to format a disk in #2 drive, the one most likely to give me trouble.
I started up the system, and, using a new 3 1/2 disk I formatted it four times, and there was no instance where I got other than 1440/1440. I tried it again, using the command:-
for i=1 to 4:format flp2_:end for i
This time I got one report of less than normal. Subsequent runs gave varying results. So I tried another two disks with similar results.
I then switched off the unit, removed the Disk Adapter, and after many runs of all disks, I had no errors. Replaced the Adapter, and started getting errors again.
I checked the adapter to see if there were any wires touching where they should not, and pried any doubtful ones away from the board. It should be noted that the board is open and it is possible for undue pressure to be applied to its components
Next day I thought I would retry the experiment, and the results were exactly the same.
Again, the initial results were fine, but after the QL had been running (warming up the Adapter?) for a short period of time, I began to get less than satisfactory results.
Conclusions:-
1. The Disk Adapter does allow up to four disk drives to run from Trump Card or the Gold Card.
2. With the adapter, flp2_ appears to be faulty in formatting.
3. Flp1_ would appear to be OK except for that one disk which I mention.
4. Until the Adapter “warms up”, it would appear to be reasonably reliable, but not always.
5. Without the Adapter, the unit formats fine.
If there is anyone who has had similar experiences in using this Adapter, I would be glad to hear from them.
This is my story, This is my song,
If you have any ideas, Just send them along.
Hugh H. Howie, [address omitted]