TS 2068 – Z88 Transfer via MODEM

Author(s): Dave Bennett
Publication: ZXir QLive Alive!
Pub Details: ZXir QLive Alive! v2 n2 (Volume 2, Issue 2)
Date: Summer 1992
Pages: 19

The Z88 has a built-in serial port. It is easy to send files back and forth to any other serial port equipped computer via null modem. A null modem is simply a serial cable with a couple lines crossed.

However some computers such as the TS2068 do not have built-in serial ports. You can buy a serial interface such as a Z-SI/O card. But this can also be done with two modems. Thus saving the cost of buying another interface.

Hook up the modems to both computers in the normal manner. On the Z88 you will have to make or buy a serial cable to plug into the modem. Most TS2068s will be using the TS2050 modem which plugs directly into the expansion slot on the back.

Instead of hooking the phone cord into the wall jack, plug it from one modem into the other. However with some modems you may also have to connect to the phone jack using a ‘Y’ connector.

Now load your favorite communication software. The Z88 has two programs available, Z88COM and ZCP. On the TS2068 try Specterm 64 or Mterm II with an Xmodem enhancement such as Loader V.

If you are using a TS2050 set the baud rates in the Z88 Panel to 300, the Parity to None and Xon/Xoff to No.

Now you will command one modem to originate and the other to answer. Modems use two different sets of tones for originate and answer. The commands for the Z88 and a Hayes compatible modem are ATO and ATA. Use the equivalent command for your TS2068 software. If the equivalent command is not available try OUT 119,2 or OUT 119,34 for the TS2050.

Initiate the commands on both computers at the same time.

The modems should connect with each other just as they do when you call an online service over the phone.

Try typing on one computer. The letters should appear on the other computers screen. If all the letters appear OK, you can try transferring files. Initiate Xmodem on both machines. This will vary with the various communication programs. Select S for Send on the machine you want to transfer from and R for Receive on the other computer. Type the filenames and press Enter on both machines at the same time. The file should be transferring. If not, check your connections and software switch settings.

This method will work for any computer. But if both computers have serial ports a null modem cable is faster and easier.

If you have two computers and two modems you may want to experiment with this method of transferring files.