The Sinclair Milwaukee Users Group (SMUG) has produced a utility that any 2068 user who owns a tv camera, camcorder or vcr should find hard to resist. It’s called a video digitiser and what it does is take still pictures from the sources mentioned above and runs them through the computer to be viewed on-screen, printed on the TS2040 and/or to be screen saved for later viewing. These files can then be modified using your favourite art program or sent to your full-size printer.
SMUG has taken a design which appeared in Sinc-Link three years ago and laid out a very neat printed circuit board which, when assembled, can then be attached to the 2068 with an edge connector or plugged directly into a motherboard. After checking to ensure that the board is installed correctly you then load in the supplied software.
Now you are ready to apply your video signal. In my case, I use a Toshiba two head vcr to produce the pictures. When I run tapes on extended play I can get a very good paused picture. I run the normal “cable out” line to a tv to view the paused picture and a source line from the “video out” dubbing jack to the RCA female jack on the digitiser board. I view the digitised picture on the monitor attached to the computer. For those of you with just one tv, SMUG supplies a schematic and parts list for a simple switch box which will allow you view the video source picture then switch over to the computer output picture. Note that you must use a source with enough power. The RF video from the “cable out” or from a ZX81 is not enough.
Once you have either a well-lit paused vcr picture or a well-lit motionless subject for your camera you are ready to use the software. The first option instructs you to synchronize the board by adjusting one of the three variable resistors until a bouncing ball stabilizes on the screen window. Then use the multiple scan option. After three or four scans a recognizable picture should have formed. Adjusting the other pots will change brightness and width. Now you can save or print.
The digitiser is available as a bare board and software, as a board with parts and software or as a complete and fully tested board with software. Contact SMUG at 5052 N. 91st St., Milwaukee, WI 53225 for more info.
The pictures below are from “Earth Girls Are Easy” in a scene that is a shameless (and very funny) ripoff of “The Fly”.

