Z88 Connections to Hayes Modem

Author(s): Phil Wheeler
Publication: Update Magazine
Pub Details: Update January 1996
Date: January 1996
Pages: 43-44

1. Official Approach from Cambridge

The following set-up is recommended by Cambridge North America (uploaded by Frank Grady on 1/6/89). (Editors notes: This file is from several years back and contains some information such as phone numbers, etc. that now may not be applicable, but the cable data is still relevant.)

“Here’s the official pinout for Z88 to any modem, courtesy of Cambridge — new tech bulletin received yesterday via phone.

 9-pin       25-pin
 male to     male to
 Z88         Modem:    Sysop's Note:  I've now tried this
-------      -------   ============  cable and it is the
 2 (TxD) --------> 2                 best I've found.  I
 3 (RxD) --------> 3                 belatedly add my strong
 7 (Gnd) --------> 7                 endorsement!!!

 5 (Cts) -------->
 8 (Dcd) --------> 20 (all wired to 20)
 9 (+5V) -------->

Cambridge offers a 1-foot cable to this spec for $19.95, but if you’re handy you can make your own. I’m happy to report that it works just fine.– Frank Grady, Detroit 1/5/89

2. Connections Recommended by Wordmongers

The following connections are recommended by Clive (Selvage?) at Wordmongers (telecon of 1/4/89 at 0530 pst). They sell comm software for the Z88, and use the Worldport 1200 modem, so they should know what they are talking about!

 Z88          Modem
 (DB-9)       (DB-25)
 ----         -----
  2 ----------------- 2
  3 ----------------- 3
  4 --| 4,5
  5 --| shorted
  7 ----------------- 7
  8 --| 8,9
  9 --| shorted

Clive added that all the modem cables they make have only three wires, per the above diagram. They also added the following re the switches in the Worldport 1200 (note that these are considerably different than the default setting I use with my portable PC and my Model 100):

SW   WM Recomm   Default   Function with WM Recommendation
--   ---------   -------   ----------------------------------
 1   OFF         OFF       Bell 103/212A or CCITT (ON in U.K.)
 2   ON          ON        Autoanswer disabled
 3   ON          OFF       Receive sense (vs. DTR sense)
 4   ON          OFF       DTR ignored (vs. Enabled)

NOW — even with these settings, and cable they specified, my Worldport would not give result codes. Worse yet, I could not even log on with manual dialing as I could before. Therefore, functionality with my portable modem deteriorated. The Hayes did work, but only after disabling the DTR sense function.

Phil Wheeler
Torrance, CA
1/20/89 (Vers. 1.06)