For several days the “A” to “G” part of the 2068 keyboard was inactive except that sometimes a sharp rap on the case would get it going again. This seemed to indicate a poor connection, or an intermittent connection in the keyboard. Other circuit parts could be a keyboard diode or even the Z 80 processor.
To eliminate a couple of possibilities, the keyboard was replaced with a spare and the Z 80A CPU was replaced. Still dead! The set of 8 diodes were next checked with a good ohm meter set on the highest scale of 20 megohms. Checking both directions thru the diodes (reversing test leads) all checked OK except the diode tied to the “A” to “G” keys which tested open. A good small signal diode will test about 3-6 megohms in one direction and well over 20 megohms in the other direction.
The diode was replaced with one testing about the same as the good ones. It was possible to do the unsoldering from the component side and excess solder was removed from the 2 holes with a soldering wick. As soon as I started to unsolder the diode it separated in the middle of the glass case. I wonder how long the glass had been fractured? To do a good job of soldering the circuit board was removed from the case so the soldering could be done on the trace side.
This repaired the bad keys and after replacing the keyboard all is back in good shape.
from the PLOTTER newsletter