TOS System Repair

See all articles from Sinc-Link v9 n2
Author(s): Jeff Taylor
Publication: Sinc-Link
Pub Details: Sinc-Link v9 n2 (Volume 9, Issue 2)
Date: March/April 1991
Pages: 28

Just after Christmas I had a look at Lyman Paquette‘s defective TOS disk system. This is the system that Timex of Portugal developed for the Spectrum in the mid-eighties. TOS stands for Timex Operating System. It was sold in the U.S.for the TS2068 (with a Spectrum bus adapter) by English Micro Systems and Zebra Systems and is often referred to as the Zebra disk system.

Anyway, Lyman had borrowed my TOS system to compare with his and had quite rightly determined that the fault lay with the interface module (the unit with the reset button). I offered to have a closer look and try to fix the problem. A little troubleshooting revealed that the fault was one of two chips on a small board which was piggybacked to the main interface board.

“No problem”, I thought,”I’ll just replace both chips and we’ll be back in business”. Wrongo, one of the chips had had its identifying numbers ground off. Literally. I could see the marks where someone had actually used a sanding disc on the chip. Why? To prevent the average home handyman from repairing these things instead of sending it back to the dealer, I guess. The trouble is… there are no dealers anymore! My system was no help, the same chips were ground down. What to do?

English Micro is long gone but Zebra still exists. I called their number and was told that they no longer supported TS computers. I already knew that but after pressing a little more I was able to get the owner’s phone number. Stuart Newfeld (I hope that’s spelled correctly) was very helpful. He did not have any replacement parts for the TOS system but he knew who did.

When Zebra got out of the TS market all their TOS parts went to Jack Dohaney (of MSCRIPT fame). A call to Jack in California and a board with the phantom PLA (programmable logic array) chip was in the mail the next day. Jack has also developed a board which combines the interface with the bus adapter in a much smaller and neater package. He also included a tape with a new set of disk utilities and he did all this on credit. He sends the stuff then you pay him. There are too few businessmen like him!

Once the new board was installed properly, the moment of truth had arrived. Power up and presto, the system booted perfectly. Thanks, Jack.

Jack says that in the very near future he will hand all his hardware business over to a dealer to tend so he can devote himself to more programming. He also says that TOS users are not limited to the 3″ drives, any drive should work.

My thanks to all the out-of-town members who offered support and even their own systems(!) while I was repairing this one. Is anyone interested in exchanging info about this system? While my Larken system is my favourite, I would like to learn more about TOS, any takers?

Disk drive controller box and plug-in interface
Disk drive controller box and plug-in interface