BB-1 8-Bit Input/Output Module Kit

Author(s): Paul Donnelly
Publication: Syntax
Pub Details: Syntax/Syntax ZX80 v4 n1 (Volume 4, Issue 1)
Date: January 1983
Pages: 8
Product:  BB-1 8-Bit
          Input/Output Module Kit
   From:  Byte-Back Company, Rt 3,
          Box 147, Brodie Road
          Leesville, S.C.  29070
  Price:  $69 assembled and tested
          $59 kit (plus $4.95 P&H)

Two inexpensive Intel 8212 8-bit I/O port chips are the heart of the BB-1. (See SYNTAX, Jan.81, for design and ZX80 use of this chip.) Byte-Back‘s module is compatible with both ZX and Timex units and neatly uses memory locations 32764 and 32766 to store input and output information. Reportedly, the unit can be used with or without various memory modules–it internally decodes its port addresses and produces a phony MREQ which prevents real memory locations 32764,5,6 and 7 from being accessed (RAMTOP becomes 32763).

BB-1 extends the ZX/TS bus for use with a memory pack or printer. Yet, the extension edge connector is out the bottom of the card and makes an awkward system set-up. To hook up external devices, connect them to buffered I/O lines and attach 0.156″ 44-pin edge connector to the top of a vertically mounted board. The BB-1 module comes with 8 output relays rated at 200 VDC and 0.75 Amp but the documentation warns against using these directly on 110 volt appliances. When building the kit, it’s a good idea not to install 4 of the relays right away–output can directly drive some TTL loads without the need for mechanical parts.

Kit documentation is comprehensive and straight-foward. However, I would have liked more extensive documentation on input devices including a parts list for photocell input, and setup for a joystick port.

BB-1 comes with its own 500 mA, 9V supply (required to drive the relays) and 7805 regulator. Using an extra power supply is inconvenient and the lack of a case detracts from what is otherwise a professionally designed double-sided board.

I used the inputs with an open collector photo-cell and push buttons with success–the relays easily switch AC power to low power devices such as a portable tape recorder, or 40 watt lamp. Contact life on the relays is limited and external power relays are recommended for heavier loads.

Overall, the system performs as advertised and provides an excellent basis for an energy management system, home protection system or general household controller.

(Byte-Back informs us that if you use BB-1 to control lights or with other energy-saving devices, you get a tax credit on the total cost of your whole system.–Ed)