Dear Editor

Author(s): H. S. Wake; Gil Grabowski; Stewart Crooks; G. I. Lobdell
Publication: Syntax
Pub Details: Syntax/Syntax ZX80 v3 n10 (Volume 3, Issue 10)
Date: October 1982
Pages: 12

To establish a feel for my ZX81 keyboard, I placed a spot of white glue on the center of each key. I used white glue because it is transparent when dry. This worked beautifully for a while but then peeled off. I was back at square one with another solution–Epoxy.

I mixed a small quantity of Epoxy, picked up a little on the end of a toothpick and placed it in the center of each key. It dries as a small transparent dome and stays put. I have been using it now for a month and have developed a feel for the keyboard which was not possible before.

H.S. Wake, San Diego, CA


I had a problem saving and loading programs on the ZX81. The problem was the noise level of the recorder when it was first turned on. By starting the recorder and allowing it to settle down (monitored via the led on the recorder) and then saving the program, it worked very well. I noticed that if I allowed the ZX81 to warm up before attempting to load the program, my success rate was almost 100%. If I attempted to load immediately I did experience errors in loading. Saving a second copy of a program back-to-back is also a good suggestion.

Gil Grabowski, Hanson, MA

SYNTAX recommends a 15 sec. delay when saving programs. Type SAVE “name”, start your recorder, wait 15 sec., then press ENTER. When the screen clears, let the recorder run, type SAVE “name”, ENTER again. Now you have the program saved twice–use these programs to find the proper volume setting on your recorder. Also use a short tape (C-30 or shorter) for better loading and saving. (We use C-10s).–KO


To prevent poor contact between the computer and the power supply or tape recorder, I arrived at the following solution.

For the power supply, I carefully removed the insulation around the tip of the plug so I could identify each of the leads. I soldered these leads to the proper contacts of the socket inside the computer. I cut the lead to the power supply, leaving about a 6-inch length of wire outside the case. I installed a $.99 Radio Shack polarized plug to complete the circuit.

I used the short leads supplied with the ZX81 in the same way for the tape recorder. This solution seems safer to me because disconnecting the computer after using it puts no strain on the weak contacts within the ZX81.

Stewart B. Crooks, Jensen Beach, FL


When I bought my ZX81 I was more interested in using published software than programming. However, I do need to know the use of all the BASIC commands and some of them aren’t very clear in my instruction book. Here’s an example of my problems (Basic Manual, chap. 14, #6): After typing in the 35 statements, and trying to run it, I got error report 2/2000. According to the report listed in the manual, a variable was used before it was assigned to a LET statement. By pressing ENTER, I could call up the first half of the listing and check it, which was okay. What I need to know is: How do I get the second half of the listing so that I can check it?

G.I. Lobdell, Estes Park, CO

To see program lines off the screen, press LIST, line number and ENTER. That line will appear at the top of the screen and you will be able to read those lines that follow.–AZ