Did You Know?

See all articles from Sinc-Link v11 n2
Author(s): Ken Shoenberger; Les Cottrell
Publication: Sinc-Link
Pub Details: Sinc-Link v11 n2 (Volume 11, Issue 2)
Date: March/April 1993
Pages: 11-16

I have enjoyed the quality of our newsletter and I have been awed by the knowledge of some of our contributors. I guess that I have assumed that everyone else has all the information that I have available to me. Our last newsletter and the out of town letter from George reminded me what assuming does. The request for information about the code for our DOS and the comment that a schematic is unavailable triggered me. Ken Schoenberger has written a good disassembler and he printed out the code and added remarks as he analysized it. It is 38 pages long with two columns per page. Rather that print out a copy to send in (I have nearly worn mine out and Ken’s comments would be lost) I have started to key it in to MScript so that it can be printed out at 15 CPI with narrow spacing. My Christmas present was a Canon Bubble Jet Printer and it seems readable at this smaller type. It is labor intensive so this installment will cover the first third of the code. The code in the “forbidden area” was given to us and I have not verified it. I hope to do this before the last installment and I will report back later.

The second item, the cartridge and I/F schematic, was something I was curious about when I first got my Larken system. I had looked over the cartridge and had started to put it on paper. To verify that I had it right I built a unit on a discarded Zebra board. After one false start with one wiring error it worked.

So the cartridge schematic should be correct. I did not recognize the marking on one diode, so I merely recorded what was on it. I used a diode that looked like it and it worked.

I do have to apologize for not using a Timex to do the schematic, but I thought it would be clearer done on a Laser printer.

I have not done anything on the disk I/F. If anyone is seriously interested in the schematic for it I could work on it after I complete the disassembly of the cartridge.

If any one knows of a m/c patch that would allow me to send the disassembly to memory instead of screen or printer, I would be interested in trying that rather than retyping the remaining pages.

My typing skills are far from perfect, so in case anyone is interested in verifying a particular piece of code here is how it was done:

1. Clear 39999
2. Load in TSDB at 60000
3. Key in a short basic routine to do a LKdos peek and poke to 40000 + address
4. Set offset so that proper addresses show in print out (send disassembly to screen or)
5. Set margin for left column
6. set printer on in TSDB
7. disassemble until page is full
8. reset margin to print right column
9. disassemble until page is full
10. repeat 5 thru 9 for next page

Les Cottrell [address omitted]

Larken Cartridge Schematic
Larken Cartridge Schematic
LARKEN CARTRIDGE DISASSEMBLY (1), first page
LARKEN CARTRIDGE DISASSEMBLY (1), first page
Larken Cartridge Disassembly, second page
Larken Cartridge Disassembly, second page
Larken Cartridge Disassembly, third page
Larken Cartridge Disassembly, third page
Larken Cartridge Disassembly, fourth page
Larken Cartridge Disassembly, fourth page