Letter from Dennis Briggs

See all articles from Update July 1992
Author(s): Dennis Briggs
Publication: Update Magazine
Pub Details: Update July 1992
Date: July 1992
Pages: 39-40

53 Gilpin Road,
ADMASTON,
Telford,
Shropshire. TF5 0BG
Tel. 0952 255895
27/5/92

Dear Editor,

UPDATE magazine Jan 1992

Several items appear in this copy which I can be of help with and perhaps expand on.

1. There is a mention of the Schoen keyboard. Keyboard products of Market Harborough, England manufactured all three types. One was the sit on top key replacement whilst the other two were pc style remote units. The Interface boards inside the QL are the same with the exception of the EPROM contents. This data is used to map the different key presses to the QL. The only item I am not certain of is the extra 8049 but it appears to be a standard one. Avoid going into raptures over these keyboards as there are problems due to the extra current drawn through the 5 volt regulator and clashes with the serial ports. On many units bits of garbage will appear on your printer. See diagram 1

2. A request was noted for Page Designer I have a copy of this program for sale and I am sure that Dilwyn Jones of Wales still has it in his catalogue. £10.00

3. The monitor converter circuit on page 40 can be made easier to install by using a low power chip such as a 74HCT04 and powering the chip from the signal lines. See diagram 2.

4. A mention is made of repairing microdrive units. The question is why repair when new replacements are so cheap ?. Ten Pounds each from me. There was a long and sorry tale about the manufacture of these units by Thorn EMI with the result that the only real cure for a faulty one is to fit a new head, a new ULA plus all the capacitors. After this it is possible it will not work as the original alignment jig is not available. If the microdrive has a pink spot on the head then Mabel at Feltham was the lady who actually did the final check on it. These units are usually very good but do suffer from the odd ULA failure. The snag with the microdrives in the early days was that there was no quality control on the goods inward section.

I keep in stock every last little tiny piece for the QL plus other items such as ROM boards, Foldover boards etc. I think also that I have a copy of every QL program of significance that has ever appeared and have had personal contact not only with the factory but with every other QL hardware producer in Europe. A reply paid letter to the above address will get your problems sorted out.

Regards

Dennis Briggs

Diagram 1: Schoen keyboard connector, rear of socket wired to the top of the board (blue, green, yellow, orange, red, brown)
Diagram 1: Schoen keyboard connector, rear of socket wired to the top of the board (blue, green, yellow, orange, red, brown)
Diagram 2: Powering a 74HCT04 from the signal line, and a PC computer to QL monitor converter circuit
Diagram 2: Powering a 74HCT04 from the signal line, and a PC computer to QL monitor converter circuit