Poor Contact
Polish the board edge contacts for the RAM almost to bare copper. Otherwise grit gets in the solder and causes intermittent contact. Coat with high detergent motor oil (Mobil No. 1, for example.); it is designed to prevent oxidation of copper, lead and tin in engines.
Put a pad between the RAM and the computer to prevent rocking. Fasten both to a board to prevent relative motion.
Some of the cable plugs go in too far for a reliable contact. Press a no. 4 split lock washer down to the base of such plugs for correct insertion depth.
Improve the contact between the grounding fingers and the case by placing foil strips in the case. This helps contact the metalized surface of the plastic. Tape the foil in by the ends.
Some computers and RAMs are inadequately masked and metallized where shorts may occur. Tape insulates some areas, but it cuts through. If you scrape the metal from the plastic near the sides or keyboard where shorts might occur, you will permanently cure the shorting problem. Remove only enough metallizing to prevent shorts; otherwise you will create an interference problem.
Heat
Cut ventilating holes or slots in the computer and RAM, then cover the openings with flyscreen to let heat out and keep junk out.
Operation
Keep your TV away from the tape recorder; some pick up the 15 KHz from the TV and feed it to the computer. (It won’t load this noise!)
Record valuable tapes on more than one cassette; store them separately. These precautions minimize damage if you mess up the work tape.
Tape Care
Label cassettes with typewriter correction tape stuck on the back. Store open end down so you can see labels on more tapes and dust falls out, not in.
Keep cassettes in plastic baby bottle bags. They are better than tape boxes at keeping out the worst problem–dust and dirt. Secure with an elastic around the long way of the cassette.
Store tapes edge down in 3×5 metal card file boxes, 5 to a box. This also protects against weak magnetic fields.
Tape Loading
Figure one shows an improved loading filter. This works even better than the one in SYNTAX (p.11 Sept.81).
Static Control
Static may cause a crash if you shuffle your feet on a rug before touching the computer. Ground yourself and the computer if necessary. On upgraded (8K) ZX80s, put foil under the overlay and ground the foil. Expose an edge of foil to ground yourself.
