See all articles from Extensions issue 4
You may also prefer to have the name reverse routine operate on a line different from line 1. Any change on this must become a permanent change in the program unlike the previous improvement which allows a selection process. The lines which tell the program to work on line 1 are listed below. In each of these lines, you will notice a reference to E$(U) – there may be something after the “U” such as in E$(U,X) but it doesn’t matter. The “U” refers to line #1. To change the line to another just change every “U” in that position to the line number you prefer.
Here are the lines to change: 7207, 7209, 7219, 7211
Remember to make a new master copy so your changes become permanent.