Op-Amp Design

Author(s): Mike McGlinchy
Pub Details: Time Designs Magazine v4 n3 (Volume 4, Issue 3)
Date: March/April 1988
Pages: 25-26

This program is a CAD (Computer-Aided Design) program to assist the user in designing 741 type internally compensated operational amplifiers. It will run on a ZX81/TS1000 or TS1500.

After keying in and running the program, you must specify the following six parameters:

1. Type: inverting, non-inverting or differential
2. Frequency
3. Voltage Gain
4. Input Voltage(s)
5. Supply voltages (VCC=VEE)
6. RI=input resistor

The computer will then calculate and list the following:

Vout
Bandwidth
Output Impedance
Feedback Resistance
RS
Phase Angle
Input Impedance

After the listing is complete, you can view the schematic diagram. This program is capable of handling the three basic op-amp configurations (i.e, inverting, non-inverting, and differential mode). Since this program is based on the popular 741 type op-amp, the following nominal values are given:

Gain Bandwidth Product=GBP=1,000,000
Ri=Input Resistance=1,000,000Ω
Ro=Output Resistance=75Ω

Also, the -3dB Bandwidth is not really -3dB, but is the ideal 0dB. Above the bandwidth the rate of closure is -20dB per decade. If the op-amp’s output voltage is calculated to be greater than the supply voltages, then VOUT will=VCC=VEE and a “clip” will appear on the list.

Sample run: list of calculated values and the inverting op-amp schematic
Sample run: list of calculated values and the inverting op-amp schematic
OP-AMP DESIGN program listing, lines 5-9510
OP-AMP DESIGN program listing, lines 5-9510