Sinc-Link comes through again

See all articles from Sinc-Link v11 n2
Author(s): Hugh H. Howie; J.R. Dodds
Publication: Sinc-Link
Pub Details: Sinc-Link v11 n2 (Volume 11, Issue 2)
Date: March/April 1993
Pages: 8

Plea for BIG EARS meets with some success. But we are STILL LOOKING for BIG EARS.

It is nice to know that when Sinc-Link asks for aid in a worthy cause, we are able to reach someone who can help. In the Nov/Dec issue of Sinc-Link a plea was printed from Jeff Dodds of Edinburgh asking for assistance in locating BIG EARS, for a project he was working on to aid the dis-abled. Here is what he now has to say.

H.H.H.


H. Howie
[address omitted]

J.R.Dodds
[address omitted]
Scotland

22 1 93

Dear Hugh

Sorry to take so long over writing to you but I’ve been in and out of hospital so much since I came back from Canada, I haven’t had time to get near my word processor. So here goes.

Since you published my appeal in your magazine I have received offers of help from California and from, I think, Indiana IN? Donald Lambert the chairman of the latter group has promised to run the letter you published in his next newsletter but says they only publish quarterly so it may take some time.

As to my own work, I have a friend here who has several ZX81’s as well as eprom programmers, so see no difficulties in programming a ZX81 motherboard. I intend that the motherboard drives an LCD display as well as steppermotors. The LCD display will show a question and wait for an input, which will take the form of Yes,No and Stop. Stop, the most important input, will put the board back to standby condition, whilst Start will wake it from that state. Yes would immediately implement the question asked and return to that same position for further input, while No would progress to the next question.

Stepper motors require a maximum of 200 herz to drive them, and 48 steps per revolution, so if I restrict each Yes input to a maximum of 48 steps I shall get one revolution of the motor. If I further reduce the drive by a fifty-to-one worm drive I will now get a seven degree movement of the arm at any motor. Not much, but enough for most purposes, and certainly enough to prevent damage. As you can see the speed will be about 1/4 second for 7 degrees of movement, or about 8 seconds for 180 degrees, so it is not fast. But then, the people using it are not likely to be in a hurry either.

Warmest greetings to your fellow members and may the New Year bring all you wish yourselves.

Yours Faithfully
(signed)
J. R. Dodds.