System 15000 on the Larken Disk System

See all articles from Sinc-Link v7 n2
Author(s): George Chambers
Publication: Sinc-Link
Pub Details: Sinc-Link v7 n2 (Volume 7, Issue 2)
Date: March/April 1989
Pages: 22

System 15000 is a an unusual sort of program, in which you, a computer hacker, are trying to break into a large computer system to retrieve money.

The program description can be paraphrased as follows:

“Richard’s company COMDATA has been ripped off by REALCO to the tune of $1.5 million on his American order. The only way to put things right is to transfer the money back to COMDATA’s bank (MIDMINSTER), by getting into the appropriate computer. Start by going to KINGSDOWN Polytechnic 672 3427. The special code list is SL312 – look for L.T.Perry & Son.”

Needless to say, this game will take several sessions to complete. It has a SAVE/LOAD routine so that one can save the key data of a game in progress. Problem is that the save and load is to tape. What we are going to do is break into the program to change the commands to enable a save to disk.

Break into the program by attempting an NMI-save to a protected disk. This will give you a DISK PROTECTED error, and you will find that you can now list the program. The SAVE/LOAD routine starts at line 330. Changes will be required in lines 338, 372, and 390, as follows:

338 RANDOMIZE USR 100: GOTO 0: RANDOMIZE USR 100: LOAD "sysdat.A1" DATA s()
372 RANDOMIZE USR 100: GOTO 0: RANDOMIZE USR 100: SAVE "sysdat.A1" DATA s()
390 PRINT AT 12,6;"PLACE DISK IN DRIVE 0"''" PRESS <ENTER> WHEN READY"

(You may use a different drive number if you anticipate saving an interrupted game to another drive)

Install an unprotected disk in your chosen drive, point the Larken DOS to it (if necessary) with PRINT USR 100: GOTO (chosen drive number). To save a running program, enter GOTO 5. The screen will go dark for a few seconds, then the program logo will appear. Press the NMI button to save the modified program.

The program has several copy protection devices in it which are worth a note.

The first line consists of a couple of pokes which are designed to corrupt line 3, so that the program will not list properly. Also, the first line is line 0, making it impossible to list. To make it listable, change the line number by entering as a direct command, POKE 23756,1. This will change it to line 1. You might be wise to delete this line altogether.

You will also notice that the screen listing is only partially visible. This is because several of the lines have “buried” colour codes in them. Eliminate these codes by using the EDIT function to bring a line down to edit it. Move the cursor slowly across the line being editted until the cursor disappears. Then DELETE (slowly) until the invisible section of the line reappears. Personally I find it easiest to continue the ERASE function until I have erased the first character to the left of the cursor; then I retype it back in. You will find this program has quite a few “buried” colour characters in it. Aside from “copy protection” reasons, you will find these codes are also used to put colour onto the screen. Look at line 330 as an example.