TS1500 memory mod

See all articles from Update July 1996
Author(s): Kevin Baker
Publication: Update Magazine
Pub Details: Update July 1996
Date: July 1996
Pages: 10

From: Kevin Baker [e-mail address omitted]
Subject: TS1500 memory mod
Date: Sat, 27 Jul 1996 23:08:53 -0700

The TS1500 internal RAM may be expanded to 32K! Timex had the forethought to multiplex all 16 address lines for the DRAM included in the ‘1500, and fully decoded the memory map. Unfortunately, the CAS signal for the DRAMs is normally only active for the 16-32K region. However, by taking RAMRM high (as with an external RAM pack), the internal memory is moved to the 32-48K region. By taking an appropriate combination of signals and dynamically switching RAMRM, you can have 32K RAM internally.

Step 1: Remove the 16K DRAMS (4116 ICs). Replace with sockets.
Step 2: Rewire the power connections. 64K DRAM chips only require 5V, not the +/-5 and 12V that 4116 require. This will also insure that a faulty switching supply doesn’t kill your computer. Be careful that you don’t cut off 5V from the other ICs.
Step 3: Run the 8th multiplexed address line. This is RA7, pin 43 on the logic array. This goes to pin 9 on the sockets.
Step 4: Populate all the sockets with 4164 64K DRAM chips.
Step 5: Since RAMRM needs to be switched dynamically, you will need to wire in a 74HC08 quad AND gate. You need to gate A15 with /M1 to get the multiplexed address correctly to the DRAM. Diagram below.

          |--------
A15 ----------|       )
          | 74HC08  )---------- RAMRM
/M1 ----------|       )
          |--------/

Step 6: reassemble your computer. Be careful with those damn keyboard flex strips!

NOTE: I have tested this on my unit. It seems to work fine, but make this mod at your own risk. Your mileage may vary!

BTW, it seems the CONTROL input on the logic array can be pulled low to disable the entire logic array.

Kevin