TYD BYTS

Author(s): Fred Nachbaur
Publication: SyncWare News
Pub Details: SyncWare News v5 n5 (Volume 5, Issue 5)
Date: May/June 1988
Pages: 11, 22

Fred Nachbaur takes issue with my comment about static electric shocks. He says that what you feel really is the electricity, rather than heat, as I suggested. I’m not going to argue, for two reasons:

1. Fred may be right, and

2. I may be wrong.

There’s complementarity for you.

Anyway, the technique does work. Fred suggests that it’s because the current density is reduced.


MEMO TO OWNERS OF TYPE C TASMAN INTERFACES

Fred Nachbaur

Re: U.P.D. and Memotext

It has come to my attention that not all (Tas)men are created equal. There are basically two types of Tasman CPI (Centronics Parallel Interface) in use. The more common version is called “Type B”, but there are an indeterminate number of “Type C” units also in use.

If you have trouble getting UPD (Universal Printer Driver) or either version of Memotext to work properly with your Tasman interface, you probably have one of the Type C’s. These are identical to the Type B except that a different port is used for checking “printer ready” status (FBh instead of BFh).

It is very easy to modify the UPD and Memotext programs to allow use with this interface, involving only a change in one of the BASIC lines. In UPD this is line number 164, in Memotext V2C it is line 354, and in Memotext V3C it is line 664. Load the program, then BREAK or STOP when loaded. Then LIST the appropriate line, and press EDIT (shift 1). This will bring the line down to the bottom of the screen. This line assigns a hexcode sequence to a string variable (I$). The fifth and sixth letters after the TASMN_ identifier have to be reversed. In other words, change

"TASMN_F5DBBF..."
to
"TASMN_F5DBFB..."

Enter the modified line, then enter the appropriate command to save the modified version to tape. Subsequently, when loading and answering “4” (Tasman) to the interface selection prompt, the program will be configured for the Type C interface.

If you have an interface not included in the menu, I’ll be happy to help you get it to work. However, I NEED AS MUCH INFORMATION AS YOU CAN PROVIDE. A copy of the documentation is a bare minimum. Specifically, I will need to know how the device communicates with the printer; whether memory mapped (which locations) or I/O mapped (which ports). Also, what value is returned if the printer is in the “ready” state during stat s checking. Address inquiries to:

Fred Nachbaur
C-12, Mtn. Stn. Group Box
Nelson, BC V1L 5P1
Canada


From the Desk of Bob Swoger of Streamwood, Illinois:

Bob claims to have found the perfect cure for crashing due to poor rear, edge card connectors on TS1000 and TS2068 computers. The primary reason for these crashes, Bob explains, is oxidation of the copper fingers at these connectors. Even connections tinned with solder are susceptible to oxidation.

The cure is as close as your neighborhood pharmacy. Go to your pharmacist and request a bottle of high viscosity mineral oil — the type commonly sold as a laxative. Using a small paint brush, apply the mineral oil to both the connector and the circuit board fingers. Put together and take apart the connectors a few times, then leave together.

The mineral oil acts as a barrier to the oxygen which causes the oxidation. When the connectors are pressed together, the oil is displaced by the copper-to-copper contact, but still provides a protective barrier to the oxygen.

The mineral oil is safe, non-flammable in normal use, and non-conductive. Use the same treatment for your recorder and power plugs and jacks.