Terminal program for use with OS-64. Z-Term 64 is a 64-column communications program with an auto-dial telephone directory of 14 entries, each with its own serial settings and macro key; ten macro keys; a 20,000-byte data buffer that can be opened, viewed, transmitted, typed into, printed, saved and loaded; and XMODEM send and receive, with or without CRC. Its setup menus cover word length, stop bits, parity, duplex and CR/LF suppression. In terminal mode a command line gives copy screen, clear screen, send macro, buffer toggle, printer toggle, hang up and pick up.
On first load the BASIC program asks for your storage device (tape, A&J Micro-Drive or Zebra floppy disk) and printer interface (AERCO, Tasman B, Tasman C or A&J), patches the code to suit, and offers to save a customised backup. The title screen reads “Z-TERM64 Communictions Software, Copyright © 1986, Zebra Systems, Inc.”. The cassette is hand-labelled “Z TERM 64 1.1”.
Program Analysis
- Lines 17–19 load the code (
ztermcod, 16,384 bytes at 47000) from tape, Micro-Drive (LOAD "@2,...") or disk (LOAD *), using the device numberdevsaved with the program. - Lines 40–67 call one of several entry points between 53875 and 53893 to set the device and printer, and line 120 starts the terminal with
RANDOMIZE USR 49770. - For the customised backup, line 200 uses the TS2068
DELETE 20,84command to strip out the setup menus, then saves the shortened BASIC and the patched code to the chosen device.
The code also holds its own character set and a default directory file, deflt.set, with entries for CompuServe and Zebra Systems.
Potential Issues
- Line 78 jumps to line 75, which does not exist; the program carries on at line 76, so it still works.
What’s in the download
- A TZX and a WAV of the tape, and a photograph of the cassette.
ZTERM64 fixes
Edwin L. Schoen’s BASIC patch, dated 4/2/87, fixes how Z-Term 64 handles the last block of a file transfer. When sending, it pads an incomplete final block with CTRL-Z characters. When receiving, it removes the CTRL-Zs from the last block. To use it, CLEAR 47000, LOAD "ztermcod" CODE and then RUN the patch. It pokes three small changes from DATA into the loaded code and then starts Z-Term with RANDOMIZE USR 49770. The patch came from an Oliger disk and is included in the download as a TAP.
Note: Type-in program listings on this website use ZMAKEBAS notation for graphics characters.


