Changing Tasword II Help Page

See all articles from Sinc-Link v9 n1
Author(s): Dick Wagner
Publication: Sinc-Link
Pub Details: Sinc-Link v9 n1 (Volume 9, Issue 1)
Date: January/February 1991
Pages: 7

Periodically questions come up on problems with using the Tasword II word processor. These have been addressed in the past when the program was “new”. A recent problem from one of our members was that the Expanded mode didn’t work on the large printer. As it turned out, the codes for expanded mode were 14 for ON and 15 for OFF. BUT, these codes are for 1 line printing which is OK for headings. This means that the code must be on the line to be expanded (double width) and not on the line above. A more universal code is 27,87,1 for on and 27,87,0 for off but the OFF code must be added at the end of the expanded line.

This Tasword II program had been reworked in the past (a used edition) and the main “HELP” page had been revised to some extent. Now the owner would like to put the page back to its original format, but how to do it? Here are the steps for the original Tasword II program–

1. LOAD TASWORD II check CAT for form).
2. After the working page is displayed, use STOP to select BASIC.
3. Edit line 15 by adding after the LOAD”—-“CODE the address and number of bytes, 54784,10751. Check this in line 710 for correctness.
4. Rewind the tape if cassette. RUN the program with this revision. Use STOP for the menu and select “load text file” (j). On “name”, input “tasword” .
5. Edit the “HELP” page as normal text, moving the cursor and making the changes desired. One suggestion is to add “CS” (CAP SHIFT) above the left set of graphics. Also change the printer to the model in use, besides any mode names. Remember, the modes must correspond to the codes and graphic symbols assigned on the printer codes screen. If you get lost, just use the EDIT key to bring up the main “HELP” page.
6. Use a fresh tape/disk and use “STOP” to return to the menu. Now choose “save text file” (s). Again name it “tasword”.
7. This time go into BASIC with “b” and GO TO 15 and reload the new text file
8. The revised “HELP” page should come up on EDIT. Check it out to see if all of the revisions are as you want them. If OK then LIST 15 and delete the added address and bytes. Now make a final save for the finished copy.

This all seems rather complicated but it falls into place if followed exactly.

Readers of Time Designs will find another method in VOL. 3, NO. 2, pages 26-29. The actual program is lines 4000-5080. Bill Ferrebee has made a major change in Tasword II that includes this subroutine. I checked his program against the original and marked each line that was different. Then I made the necessary revisions/additions. His method is of changing the “HELP” page is “self contained” but is slow. This is the reason for the flashing “WORKING” sign, just wait until it stops. After all, it takes time to make 1537 loops. Actually it is faster than the method given at first.

Note: Thanks to Norm Lehfeldt in TIMELINEZ of unknown date for the procedure for revising the “HELP” page.

from The Plotter n/l of Clackamas County


GEOMETRIC DESIGN
GEOMETRIC DESIGN